Introduction to my blog!

By


 Hi! My name is Charlie, and this is my 2003 Mazda Mx5. It was originally fitted with the B6-ZE 1.6 litre engine.

I am currently undergoing a full 'nut-and-bolt' restoration! Also planned, is a Jaguar AJ30 3.0 litre V6 conversion, without using the Rocketeer kit. 


I have been using Instagram to write about my progress, however I am not a massive fan of the layout and follower interaction. 


Hopefully this blog can help me keep motivation and help you work on your own Mx5!


If you want to get in contact with me, my Instagram is @charlesfinnthomas (personal account) and @cftmx5 (for all things mx5!). 

Comments

Post a Comment

Popular posts from this blog

Fuel Tank Restoration Guide

By
Image
  This guide will show you how I turned my 17 year old fuel tank into one that looked a day old! To get access to the fuel tank, you must first drop the rear subframe and all the other bits that come with that task (guide coming soon).  Once the subframe assembly is out of the way, the fuel tank can be removed!  Remove the fuel filler tube and return from within the boot.  Disconnect fuel pump electronics and fittings from within the cabin (hidden under parcel shelf). Not necessary for everyone, remove fuel filter with fuel lines.  4 Bolts hold the fuel tank to the chassis, the fuel tank can now be removed! Once the tank is removed, strip it to the bare fuel tank. This includes removing fuel pump, roll-over valve, rubber mounting tabs, foam strip, and the probably very rusty heat shield. You'll probably snap a few bolts removing the heat shield, these can be easily drilled out once it is off or leave them flush and pretend they were never there! I will not be utilizing the heat shi
Read more

Washer bottle relocation on a budget!

By
Image
  I managed to pick up a washer fluid bottle relocation tank when I first got the MX5 for £15.  After carrying out some research it appears to be from 'Universal Intercoolers'. It comes in a kit which basically makes this whole post pointless, but I got it second hand as just the relocation tank.  The original kit is illustrated below.  It includes a pump, wiring, hose line, and the relocation tank. If you look at the tank  on the bottom left corner, you can see the fitting for the hose to push onto. This means the pump does not mount to the tank and requires additional mounting.  My idea is to remove the nib and replace with a hole and grommet for the OEM washer bottle pump.  Firstly, I cut the nib off with a hacksaw. As you can see in the picture, it sits pretty close to the corner, if i were to drill the original hole position it would have no wall thickness left for a grommet. Basically, I center punched more to the left and up from that hole so that when I drill the hole f
Read more